ENTU 763GO

Optical-Electrical-Optical Converter

The ENTU 763GO is an Optical-Electrical-Optical (OEO) signal converter, which has two SFP sockets. It can convert two optical digital signals of SFP modules, which maybe different wavelength, different distance or different mode (single mode/multi mode fiber) and same speed at 100M Hz or 1G Hz auto detection. It allows the operator to maintain the ENTU 763GO with IEEE 802.3ah Link Layer OAM and TS-1000 OAM at CO or CPE mode. 

.Protocol transparent 3R fiber media transponder/repeater (Re-amplification, Re-shaping and Re-clocking)
Data rates up to 1G
.Extend transmission distance from fiber
.Perform optical repeater function
Support SFP DDM (Digital Diagnostics Monitoring)
.Comply with IEEE 802.1Q Tag VLAN
.Support Q-in-Q function
.Maximum Frame size 9K bytes
.Ethernet bandwidth Control
.LED indicators for ease of network diagnostic
.Prompt indication on network failure
.Firmware upgrade via HTTP
.Built-in IP-based WEB GUI configuration and maintenance
.Centralized install with iEAC-16 via web or SNMP management
 

Model

ENTU 763S/GO Stand alone Ethernet repeater

ENTU 763C/GO Card type Ethernet repeater

 

Network Interface

Connector type: SFP (MINI-GBIC)

SFP type: 100Base-FX SFP modules

1000Base-X SFP modules

Support SFP DDM (Digital Diagnostic Monitoring)

Temperature, Voltage, Current, Tx Power, Rx Power

For detailed wavelength and distance of SFP modules, please refer to SFP Transceivers datasheet

 

User Interface

Connector type: SFP (MINI-GBIC)

SFP type: 100Base-FX SFP modules

1000Base-X SFP modules

 

Ethernet feature

Link Status

Management IP: static IP or DHCP

Ethernet bandwidth control

Complies with IEEE 802.1q Tag VLAN (including Q-in-Q)

Jumbo frame to 9k bytes

 

Management & OAM Functions

Configuration via craft port VT-100 and WEB GUI

Console: RJ45 connector (RS232C)

HTTP firmware upgrade

RMON counter

Front panel test button for easy loop healthy testing

Reset button back to factory default

 

Support IEEE 802.3ah Link Layer OAM(network side)

-           Auto discovery

-           Link monitoring

-           Remote loopback test

-           Remote fault detection

Link Fault Reflection

Dying Gasp

Critical Event

Support TS-1000 OAM(network side)

-           Loopback test

-           Reset remote device

-           Get remote device information

-           Remote port setting

 

LED Indicators

PWR, WAN LNK, CO, TST, TP, RF, LAN LNK

Power Requirement (Stand alone)

AC/DC, DC/DC external power adapter (12V, 0.5A)

Power consumption: 3.3W

Dimension

87(W) x 172(D) x 24(H) mm

Operating Environment

Operation Temperature: 0 o C ~ 50 o C

Storage Temperature: -20 o C ~ 70 o C

 

Humidity: 90%, non-condensing