Model
- ENTU 773S:Dual link Gigabit Ethernet NTU Standalone
- ENTU 773C:Dual link Gigabit Ethernet NTU Card Type
Network Interface: Optical SFP
- Connector type:Two SFP-LC
- 100 Base-FX or 1000 Base-X SFP port
- 100 BASE-FX with the transmission speed of 100Mbps
- 1000 BASE-X with the transmission speed of 1000Mbps
- Automatic Laser Shutdown (ALS)
- IEEE 802.3ad Port Trunking: Bandwidth Aggregation by join the trunk hash
- Support SFP DDM (Digital Diagnostic Monitoring):
Compliant with SFF-8472 SFP DDM (Digital Diagnostic Monitoring), include temperature, supply voltage, bias current, transmitted and received power
- For detailed wavelength and distance of SFP modules, please refer to SFP Transceivers datasheet
User Interface: Ethernet
- Connector type:Two shield RJ-45 jacks
- Auto-negotiation 10/ 100/ 1000 Base-T for speed and Half/ Full duplex
- Auto MDI/ MDIX detection and Manual setting
- Support cable diagnostics feature for copper wires
Networking Function
- Supports Link Fault Pass Through (LFPT)
- IEEE 802.3x Flow Control
- Ethernet bandwidth control
- RMON counter
- Ethernet Port Mirror
- Maximum frame size up to 9k byte (Jumbo Frame)
- Complies with IEEE 802.1p QoS
- DHCP & SNTP Client
- VLAN Translation
- IEEE 802.1q Tagged and Port based VLAN
- IEEE 802.1ad Q-in-Q
- Ethernet Loop detection and prevention
- IEEE 802.1d STP, IEEE 802.1w RSTP
- IEEE G.8032 Ethernet Ring Protection Switching
- IEEE 802.3az Energy Efficient Ethernet
- Support Link Aggregation Control Protocol (LACP)
Management & OAM Functions
- Quick setup MDC or Ethernet Switch mode via DIP switch
- Configure via craft CLI, Telnet (SSH), WEB (HTTPs) or SNMP V1/ V2c/ V3
- RJ45 connector (RS232C):Craft or Serial over IP selectable
- FTP/ HTTP firmware upgrade
- Reset button back to factory default
- Support warning threshold for setting the upper and lower limit of optical parameters to send a warning message
- Support syslog standard for message logging
- Support IEEE 802.3ah Link Layer OAM
Link monitoring
Loopback test
Dying Gasp
Reset remote device
Change remote IP address
- Enhanced Login security check
Three access levels for administrator, operator, user, and operation log
Support login password complexity of 6 characters, lower and uppercase letters, digits, special symbols
Anti-camouflage attack mechanism:lock IP and delay login
LED Indicators
- PWR, ALM, LNK1, LNK2, UTP LNK/ SPD, DPX
Power Requirement
- AC/ DC, DC/ DC external power adapter (12V, 1A)
- Power consumption < 7W
Dimension
- ENTU 773:89 (W) x 175 (D) x 25 (H) mm
Operating Environment
- Operating Temperature
ENTU 773S、ENTU 773C:0ºC ~ 50ºC
ENTU 773S/H:-20ºC ~ 65ºC
- Storage Temperature:-20ºC ~ 70ºC
- Humidity:90%, non-condensing
Note:Features and specifications are subject to change without prior notice